2″ disk TOWER

Designed to store your sanding disks until you need them!

The TOWER is stackable, add the number of floors you need. Each floor has 2 rooms holding about 30-40 disks each. Since it is stackable, you can add on as needed.
This can sit on the bench ready to offload into the disk caddy for use at the lathe.

Add the number of floors you need, then add magnets and wall mounts if you need them.
Magnets are used on the back of the top floor (2x) and on the back and the bottom of the “ground” floor.

These are 3d printed in house and made from 100% USA filaments, so made in the USA (hooray!)